MULTIBOND is a high strength ready-to-use water-based vinyl, carpet & wood adhesive, suitable for installations of various decorative floor and wall finishes. Its advanced polymer technology ensures high bonding strength – twice the bonding strength of contact cement. Its thick formulation with body allows it to correct minor surface imperfections and fill gaps between the substrate for an even and professional finish.

  • Fast & Easy
  • Water Resistant
  • Odorless & Non-toxic
  • Nail free installation
  • No shrinkage
  • High bonding strength
  • Water based

Coverage:

Multibond Coverage (approx.)
4kg20 - 24m²
Calculation is based on using a 1.5 x 1.5 mm notched trowel. Consumption is dependent on substrate condition.

Packaging: 4kg plastic container

Storage & Shelf Life: Store in a cool dry place. Multibond Vinyl, Carpet & Wood Adhesive will remain usable one year from date of manufacture.

Warranty: Due to variety of applications, different working methods and the various properties of bases, we cannot assume responsibility or liability with regard to the application of our products. Our guarantee and liability are restricted to the quality of our products at the time of acceptance of the customer of such products. In no case shall our liability extend beyond replacement of defective products, if any, found at the time of acceptance. For all deliveries and services, our General Sales Condition including warranties stipulated for each case are valid.

Surface Preparation

The surface must be fully cured, structurally stable and level. Make sure the surface is clean and free from paint & contaminants such as dirt, dust, loose material, oils and chemicals. If needed, acid etch the surface area to be applied (e.g. on existing polished or waxed floors).

How to use Multibond

1. Application

Spread MULTIBOND over a clean and dry surface and comb evenly with a recommended notched trowel.

Note: Using a 1.5 x 1.5mm notched trowel will prevent lump formation, as it enhances the adhesive’s body to correct minor surface imperfections.

2. Installation

Wait 15 minutes, then positioning each piece of vinyl tile or parquet before tamping with a rubber float.