ABC ACRYLIC SEALANT is a flexible, water based, non-toxic gap filler for indoor and covered outdoor use prior to painting or other finishing work. ABC ACRYLIC SEALANT can be applied on joints to prevent cracks between gypsum board, wood or concrete. It can also be applied between walls, ceilings, corners, door/window frames, walls and along baseboards and cornices.
- 100% acrylic
- Paintable
- Non-slumping
- Low Shrinkage
- Flexible
- Good Sanding properties
- Non-staining
- Superior adhesion
- Water based
- Non-toxic
Consumption of Firestop 300ml (approx.)
Application Width 5 mm 10 mm 15 mm 20 mm 25 mm
Application Depth 3 mm 5 mm 8 mm 10 mm 12 mm
Coverage Area 20 m 6 m 2.5 m 1.50 m 1 m
Note: Minimum / maximum joint width 5mm / 25mm (recommended joint depth / width ratio is 1:2)
Color: White
Packaging: 300ml cartridge
Storage & Shelf Life: When stored in a cool dry place & in its original unopened packaging, ABC Acrylic Sealant will remain usable one year from date of manufacture.
Warranty: Due to variety of applications, different working methods and the various properties of bases, we cannot assume responsibility or liability with regard to the application of our products. Our guarantee and liability are restricted to the quality of our products at the time of acceptance of the customer of such products. In no case shall our liability extend beyond replacement of defective products, if any, found at the time of acceptance. For all deliveries and services, our General Sales Condition including warranties stipulated for each case are valid.
How to use Silicone Sealants
1. Application
a. Use a standard caulking gun to dispense the sealant. Tool immediately, within 5 minutes of application, with a spatula to spread the sealant against the back-up material and joint surfaces. Sealant will begin to skin on the exposed surface in about 10 minutes and cure will progress inward.
Note: The use of a caulking gun ensures even distribution for a professional finish.
TIP: Hold the sealant gun at an angle of 45° while pulling the gun
towards yourself. Find the right working speed to properly fill the necessary gaps.
b. For areas with deep surfaces: Ensure the sealant is in contact with both sides of joints and gaps. Use foam backer rods to establish good bonding at the sides and to control the depth of the sealant.
2. Finishing
Wet your finger with soapy water to smoothen out the silicone sealant seam. The soap prevents the sealant from sticking to your finger. Remove any excess sealant from surface with knife or spatula. Depending on humidity & temperature, applied sealant is touch dry after approx. 30 minutes.
Note: Protect from water exposure for at least 4 hours after application.