AQUASHIELD PLUS is a two component cementitious flexible waterproofing compound formulated for direct application over concrete surfaces. Its two-component system utilizes a blend of cementitious materials and the latest polymer technology. This highly effective waterproofing is flexible, non-toxic, easy to apply and readily accepts any kind of finishing. Aquashield Plus is spread in a paint-like manner to bridge hairline cracks and for total coverage. Its water base formula makes Aquashield Plus an economical and safe product to use.
- Stays Flexible
- Superior Bonding
- Time Saving
- Fast & Easy
- ASTM D412 (USA) American Society for Testing and Materials
- ASTM D4541 (USA) American Society for Testing and Materials
- ASTM D836 (USA) American Society for Testing and Materials
- ASTM E96 (USA) American Society for Testing and Materials
The surface must be relatively smooth, fully cured and structurally stable. Depending on the orientation of the application area, the surface must be level (horizontal surfaces) or upright (vertical surfaces). Make sure the surface is clean and free from contaminants such as dirt, dust, loose material, oil and chemicals. In areas with continuous water seepage, use Aquaplug Hydraulic Cement to instantly stop the penetration of water prior to the application of Aquashied Plus. During hot and windy conditions, moisten the substrate thoroughly. Aquashield Plus is compatible with concrete surfaces & fiber cement boards.
Use ONLY non-absorbent materials such as plastic pail or galvanized iron sheet as mixing base. Pour Aquashield liquid component into a container & add Aquashield powder. Stir to attain a smooth and lump-free consistency.2. Application
Using a Tampico Brush is the best & fastest tool used to apply Aquashield. This flexible cementitious waterproofing must be applied in two coats and spread in a paint-like manner for total coverage. The coats have to be applied in two directions – horizontal and vertical, to form a weave like coating to ensure all surfaces are covered & no pinholes are created. Wait 4 – 6 hours before applying the second coat. If a third coat is required, observe the same time interval and procedure prior to application. For areas exposed to direct sunlight (e.g. roof deck) cover Aquashield Plus with a damp cloth or plastic sheet to prevent premature curing. In cases where water seepages or infiltration is heavy, 3- 4 coats might be necessary.3. Finishing Any waterproofing membrane must at all times have a concrete topping or plaster to protect it from any possible damage.
Due to variety of applications, different working methods and the various properties of bases, we cannot assume responsibility or liability with regard to the application of our products. Our guarantee and liability are restricted to the quality of our products at the time of acceptance of the customer of such products. In no case shall our liability extend beyond replacement of defective products, if any, found at the time of acceptance. For all deliveries and services, our General Sales Condition including warranties stipulated for each case are valid.