How to use Aquashield Plus

1. Mixing / Paghalo


1. Use a clean plastic or a non-absorptive container as mixing base.
2. Shake liquid (Component A) well.
3. Pour the liquid (Component A) into the container & add the powder (Component B).
Stir to attain a lump-free, slurry consistency.

Do not add water to change the consistency of the mix.

2. Surface Preparation / Paghahanda ng paglalagyan

Concrete surfaces must be structurally sound, free of form oil, dirt, dust, loose particles & other contaminants.

Dampen surface prior to application to prevent premature drying-out. During hot & windy conditions, dampen thoroughly.

3. Application / Pagpapahid

Apply the initial coat using a stiff bristle brush. Curing time: 4 – 6 hours. Dampen slightly and apply second coat. If a third coat is required, observe the same time interval and procedure prior to application.

  TIP #1: In areas where continuous water seepage is present, use AQUAPLUG hydraulic cement to instantly stop the penetration of water prior to the application of Aquashield Plus.

  TIP #2: For areas exposed to direct sunlight (e.g., roof deck, lanai, swimming pool, etc.), cover with damp cloth or plastic sheet to prevent premature curing. A minimum of 2 coats is always required. In cases where water seepages or infiltration is heavy, 3 – 4 coats might be necessary.